Cisco Systems RF Gateway 10 Guida di Avvio Rapido Scaricare il pdf (Pagina 8)

Figure 3 Chassis Installation Bracket

Note After the chassis is installed and secured to the rack, the chassis installation brackets can be removed from the rack.

The brackets are not needed for supporting the chassis when all the rack-mount screws are installed.

Installing the Chassis Installation Handles

This section explains how to attach the chassis installation handles to the chassis.

Before installing the chassis in the rack, it is recommended that you install a chassis lifting handle to each side of the chassis to

aid in lifting the chassis onto the rack.

Note It is recommended to install the two side chassis installation handles while unpacking to aid in moving the chassis off

the palette.

Note Chassis installation handles should not be installed if the chassis is to be mid mounted.

To install the chassis installation handles on a Cisco RFGW-10 UEQAM, complete the following steps:

Step 1 Locate the two M5 threaded holes on the upper center of each side of the chassis that align with the handle captive

screws.

Step 2 Install the two chassis installation handles on either side of the chassis and tighten the captive screws.

Chassis

installation

bracket

273445

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Nessun commento

Cisco Systems RF Gateway 10 Guida di Avvio Rapido Pagina 8